Replacement Exhaust H section in Polished Stainless Steel

I supply manufactured replacement V Max exhaust H sections (the bit that rots out) in Polished Stainless Steel. This part is intended to replace the steel H section pipe between the front two cylinder down pipes and the cans/silencers.

After a lot of design changes I have decided to make these so they fit over the existing 45mm down pipes rather than at the point where the exhaust narrows down to 35mm as per the originals. The reason for this is that the original pipes rot so badly that it is hard to get the original section out of the front down pipes (mine were rotten solid).

The pipes are made in Polished Stainless Steel and are supplied with 3 stainless steel clamps (they were jigged of my bike).

It has taken a long time to find a company who can make these to a top notch level and I have TOTAL faith in the product. I have had one on my bike now for some time and it's a great improvement. For fitting instructions click here.

The pipes are polished to a good standard though there is the odd line where it has gone through the bending machine.

I can have it polished to 'show bike standard' if required at an additional cost (see below). Please mention this when ordering as it adds 7 days on the despatch time.

Thanks to various people, friends, and the V Max Forum who helped get the product to where it is. Your comments and advice have been a great help.